I needed more space, so I set about creating a mount to stack my CFS and Space Pi Plus on top of each other.

I designed this stand so that it could be easily printed on the build plate of my Creality Hi. There are plenty of models suitable for a K2 Plus, but almost none that print easily on a Hi without complicated cut-outs.

The model consists of just three parts:

The base
The legs
The top

How to build it ?

Just let the print profile guide you 😅

The base and the top are both made up of the same piece, repeated four times each. A dovetail joint is used to join each corner together to form a 300x300 square.

I think it's better to glue it :

Once the base has been assembled, just repeat the operation to have the Top.

And finally, assemble with the four legs and you'll have a stuning stand for your CFS :

You can glue the legs. I didn't and I have no problem so far.

And what about the height ?

You can adjust the height as you wish by changing the height of the legs. In your slicer, only change the Z-height (whilst keeping the X and Y dimensions the same!) and you will be able to vary this height.
Please note that you will not be able to assemble a leg that is less than 40mm high, as the minimum final height of the stand is 140mm.

Let me know if you need any remix. I can easily tune the dimension to fit your needs

__________________

I have other tools for 3D printing, just have a look below if you want :-)

Hi / Sparkx i7 single or dual top Spool Holder

https://www.crealitycloud.com/model-detail/creality-hi-top-spool-holder

PTFE Guide for Hi / I7 Spool Holder

https://www.crealitycloud.com/model-detail/ptfe-guide-hi-i7-spool-holder
Soleyin RFID Tag Holder

https://www.crealitycloud.com/model-detail/rfid-cfs-soleyin-ultra-pla

creality