Another Bat!

Description

To bring a little balance for your day! These bats are so addictive. I couldn't stop printing them and finding the ideal balance. I hope you also enjoy. Printing recommendation Bat - Infill at 100% are better to achieve balance, but 10% will do (I had no problem) No support, just skirt for bed adhesion. I printed using a ender 3-S1 with Sonic Pad at 160mm/sec with no problem (black PLA). You may scale at your convince, but larger is easier to achieve equilibrium. Stand - Use Brim (at least 10mm) for bed adhesion. If you iron (Cura's feature) the last top layer, you will get smooth balance. In case you have problems to get balance, cut small pieces of the bat head (inferior part, where mouth would be) so you can build a small platform. This should not be necessary, but I guess the bat is subject to printer characteristics and may vary.