This snap-fit dash base is designed specifically for the 3rd Generation Toyota Tacoma (2016–2023). It creates a stable, flat mounting surface on the factory dashboard contour, allowing you to securely attach accessories such as a dashcam mount, GPS unit, phone mount, or small control module. In my case, I've attached my Garmin Dash Cam 35 with E6000 adhesive.

The underside geometry conforms to the Tacoma’s dash profile and uses a friction-based snap fit to stay in place without permanent modification. No drilling or adhesives required.

Ideal for:

• Dashcam adhesive pads

• 3M VHB-mounted accessories

• Magnetic phone mounts

• Small switch panels

The top surface is intentionally flat and clean for universal compatibility.

Vehicle Compatibility

• Toyota Tacoma 3rd Gen (2016–2023)

• Designed around OEM dashboard geometry

Fitment may vary slightly depending on trim level and dashboard material.

Printing Recommendations

Material:

• PETG (recommended for heat resistance inside vehicles)

• ASA (best for high heat + UV resistance)

• PLA only if vehicle interior temperatures remain moderate

Interior dashboards can exceed 60–70°C in summer sun. PLA may deform in hot climates.

Layer Height:

• 0.2 mm (standard)

• 0.16 mm for cleaner surface finish

Nozzle:

• 0.4 mm

Infill:

• 30–40% gyroid or cubic

This provides good rigidity without excessive material use.

Perimeters:

• 4 walls minimum

Dash components benefit from stronger outer walls.

Top/Bottom Layers:

• 6–8 top layers

• 5–6 bottom layers

This model prioritizes:

• Snap retention without fasteners

• Heat durability

• Clean factory appearance

• Universal flat mounting surface

If your print feels too tight, reduce scale to 99–99.5%.

If slightly loose, increase to 100.5%.

3rd Gen Tacoma Snap Fit Dash Base

HoffTalk

Tetapan Cetak(1)

0.2mm layer, 2 walls, 15% infill

Penerangan

Lesen

Tag

Model Berkaitan