Print/Useage Information

I printed this with 2 walls and the cable holder was modeled to holder cords with a diameter of 4mm. The cord in the picture is 4.2mm and holds with a tight fit, although the cable can slide up and down through the holder with ease of use. The model was created for a desk with a thickness of 15mm with 0.2mm offset on the top and bottom to slide on and off easily.

I will modify and upload a better cable holder when I have the time.

Design Concepts

This minimal cable holder is designed to provide a simple and efficient solution to keeping your cables organized and intact on your desk or workspace. Its sleek design is unobtrusive and blends well with most environments.

Uses

Primarily used for organizing charging cables, USB cables, and other cords that require frequent access, preventing them from slipping off desks.

Printing Recommendations

For optimal performance, print using PLA or ABS for flexibility and strength. A layer height of 0.2mm is recommended with an infill of around 20%. I printed this with 2 walls and supports under the top (longer side of the holder), while printing the model vertically so the rounded parts can print without any issues.

Assembly Instructions

The cable holder is a single piece, making it very user-friendly. Simply place it on the edge of your desk or any suitable surface, and it's ready to use.

Optional Add-ons

Oen thing you can do to make sure this hold better is apply some double sided sticky tape to any face on the inside of the holder.

Minimal Cable Holder

Henderson590

Tetapan Cetak(1)

0.2mm layer, 2 walls, 15% infill

Penerangan

Lesen

Tag

Model Berkaitan