Hang in there, I'm so new I don't know how to get the print files over here.

Designed in Tinkercad, sliced in Creality Cloud, printed on K1C with Creality Hyper PLA silk - rainbow.

I'm still learning about supports, they made a mess, I'm not sure they were even needed except for maybe at the spout? Overall, they pot printed well, very sturdy. My Mom was thrilled to receive it. I'm sure it'd hold water/soil but wanted it to be a keepsake after the plant dies off so I lined it with plastic.

Print time was 13 hours when printed large enough to house a 5" plant pot. I made a smaller version that took 8 hours.

Supports: 15% at 45 degrees

Infill: 15%

Retraction not set, this led to some stringing that needed to be cleaned up.

Nozzle .4mm, temp was default, I haven't messed with that yet.

Thank you for checking out my first creation, I apologize for the incomplete print parameters but I don't think I'm doing too bad for only owning the printer for 8 days. Happy Mother's Day!

Fail Cetak：

Mom Tea Pot Planter