https://social.thangs.com/m/433395 Found the model on Thangs by PrintObsession. Super duper happy with the way it turned out. My first larger model that has turned out super well. Only real issue is with a little extra banding of the first few layers underneath the overhangs. Inland PLA in my Ender 3 V2 with v4.2.7 main board, Capricorn Bowen tube, yellow bed springs, running mriscoc's Professional Firmware, calibrated E-steps,and first time I ran a print using OctoPrint. Sliced using Cura 5.2.1 Standard Quality 0.2, calibrated flow rate, using Tree supports, Lightning infill, and a brim for adhesion.