This is a cute print. Many thanks to the designer. Makers will likely need to use glue stick on the bed for good adhesion on 1st layer. Especially for the little clips that hold the halves together. No supports required. This was done on a V3 SE in PLA at 200C/60C in about 3.5hrs at 80mm/s | Creality Bulutu

 Designers 

 Tezgah

 Mesajlar

 Türkçe 

 Creality Bulut Uygulaması

Explore  Store Koleksiyonlar Kampanya & Yarışma Liderler Sıralaması  Toplum Ürünler  Downloads  Blogs









Creality Bulutu





01:03 09-08-2024

Takip Et

 Rapor

1



Yorum



Resim