I finally made my own mount for the Nebula on the CR-10 SE.

This should work for other cameras as well as long as they aren't too tall and hit the bed as long as they still have 1/4" thread to match the hole or you could use velcro or glue as well to attach it.

This also works as a cable control for the Extruder as well, It's a combo but works great for just the Extruder as well.

I have included an angle of what the camera feed looks like as this angle helps greatly for monitoring layer adhesion and should make the AI feature work more reliably.

This also makes a more consistent clear picture since this setup minimizes vibrations experienced by the camera and keeps the camera out of the way of all models since it still sits a few millimeters above the current print layer.

Make sure that you use a USB Extension on your camera or you will not be able to reach full Z-Axis height.

Check the final picture for locations of the zip ties to hold the cables out of the way.

Make sure to print this out of PETG or better to prevent heat sag over time, especially if printing in an enclosure.

My print settings were 225-235 degrees and 70-75 on the bed with no supports.

Prints in less than 21 minutes and consumes less than $1 in filament.

I put a lot of care into this design and this was like my 5th iteration.

I do respond to comments if you have any questions.

Thank you for considering purchasing this print and happy printing :)

CR-10 SE Camera/Cable Mount

Vruasix

Налаштування друку(0)

Опис

Ліцензія

Теги

Схожі моделі