I decided to try this dragon design from [%9177532259]and it went well until around the 80% completion point.I used gray PLA and the print took about one day to complete. Yes, I did allow the print job to complete because I wanted to see the outcome. Although the dragon is missing its bottom jaw, it still doesn't look too bad. I may try it again at a later time.This was printed on a Sermoon v1 Pro. | Creality Cloud

 المصممين 

 منضدة عمل

 الرسائل

 العربية 

 تطبيق Creality Cloud

Explore  Store المجموعات مسابقات المتصدرين  مجتمع المنتجات  التنزيلات  المدونات













23:58 02-18-2024

متابعة

Mortas Dragon - Death Dragon - PRESUPPORTED - 32 mm-0

Mortas Dragon - Death Dragon - PRESUPPORTED - 32 mm-1

Mortas Dragon - Death Dragon - PRESUPPORTED - 32 mm-2

Mortas Dragon - Death Dragon - PRESUPPORTED - 32 mm-3

Mortas Dragon - Death Dragon - PRESUPPORTED - 32 mm-4

ملف الطباعة：

mortas-dragon-full

mortas-dragon-full 

 Sermoon V1 Pro

 PLA

 0.15mm

 1d 0h

GoodOlAndyCDN

 2

 3

 ابلاغ

2



《Dragon Contest 》 الأعمال

تعليق



صورة