This is my print of "Spinning Top" I printed this without supports, and my printer did an amazing job. It only has one small bump because of overhang, other than that, the underside is really smooth. The spinners performance isn't the best, i would probably have made the tip a bit more dull since it had difficulties spinning upright. Printer: "Ender-5 pro" Supports: No Scale: 100% Sliced with: "Ultimaker cura" Layer height: 0.2 mm Filament used: CR-PLA White Printing time: ~ 0h 30m Print speed 80mm/s This is an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c "November 3D Printing Event" https://www.crealitycloud.com/contest/november-3d-printing-event