Trimmed Vampire Ankh Pendant

Description

Created by - __Vincent__ Link - https://www.thingiverse.com/thing:2614539 This is a crude cut (done using FreeCAD) of the STL of the original Vampire Ankh Pendant by gothianna. I needed it because the original object, although very nice looking, did not properly slice in Cura 15.x : the 'winged' part would end up having lines that would not join the others, thus printring in mid-air. I cut the STL to remove those and it printed very nicely. Notes: The object is not manifold after the cut but Cura did fix it and it printed nicely. The center part of the 'winged' area which was cut did not hold well and had to be glued on to hold. Probably a side effect of my cut.