Not Mine
Found: https://www.thingiverse.com/thing:5136948
Rafts:
No
Supports:
No
Resolution:
0.12
Infill:
100%
Printing Instructions
v1: 1-part print. Print as is for full-block size or scale down height to 11.4mm (uniform scaling off) for slab size.
v2: 2-part print. Find the files for the size of your choice. Print outer part with an opaque filament. Print the inner layer with translucent or white filament for better glow effect or a color of your choice to represent the ore.
Check out the print settings section for more info.
Compatibility
These are designed and tested to fit on outemu switches so any cherry and cherry clones should fit as well. You may refer to the chart (look for the stem type) on this link to check out the compatibility of your switches.
Tips
These are printable with 0.4 nozzle, but the keycaps shown in the photos are printed with 0.2 nozzle. I tried printing with 0.4 but I just wasn't satisfied with the result.
If the stem of your printed keycaps don't fit the switch or are too loose, you can try adjusting the hole horizontal expansion setting in Cura to fine tune the hole sizes.
For v2, scaling the inner layer to 99% and setting hole horizontal expansion to 0.02 worked best for me
10 files
Be the first to add a Make!
Add a Make
Picture
Contacts
Report comment
Delete
Upload 3D Model
Pricing
Model Sales & Purchase Agreement
Purchase
Copyright Notice
Report Model
Report Model
Creality Cloud protect designer's copyrighted works
Slices
Submit an Appeal
申诉
Coupon
Add to folder
We use cookies to ensure you get the best experience on our website
Got it!