Found a sword shaped bookmark (by mdraz1997 https://www.thingiverse.com/thing:4831951, check it out) and thought about what other swords were iconic enough to use for this purpose. The result is right here.
I used the Buster Sword by MoustachePolice as a base for this bookmark. I flattened and elongated the blade to make it work as a bookmark. Then I split the sword in half so it prints flat without supports. Middle piece should be flexible enough to wrap around a page in your favorite Final Fantasy novel so you never lose track of your progress.
It's quite big but it prints in about 45 minutes at 0.2mm layer height.
NOTE: Don't push down too hard on the bookmark, it might damage your book because of the sharp edges.
Printed at 0.2mm layer height
2 walls, 4 top 4 bottom
Be the first to add a Make!
Add a Make
Upload 3D Model
Model Sales & Purchase Agreement
Creality Cloud protect designer's copyrighted works
Submit an Appeal
Add to folder
All-in-One 3D Printing Platform
Subscribe to Creality Cloud
Be the first to get the latest news from Creality Cloud