I experienced under-extrusion problems on my K1. One of the issues causing the filament thread to be hard to feed is that the spool holder is fixed and does not rotate. I therefore created a spool holder that can use the same bayonet mount as the original, but rests on two bearings, so that it spins freely.
In addition I rerouted the Bowden filament tube, so that it is not captured within the link chain. These two fixes solved my under-extrusion problems.
The FreeCAD design file is included. Change it to your liking.
BOM:
1 M8 Bolt at least 78 mm
1 M8 Locknut
4 M8 washers, ca 16mm x 1.5mm
2 Bearings. Any 608, 608zz or 608rs should work
If you are in a pinch, you can skip the outmost and inmost washer. I had to do so, since I used a too short bolt.
2 files
Be the first to add a Make!
Add a Make
Picture
Contacts
Report comment
Delete
Upload 3D Model
Pricing
Model Sales & Purchase Agreement
Purchase
Copyright Notice
Report Model
Report Model
Creality Cloud protect designer's copyrighted works
Slices
Submit an Appeal
申诉
Coupon
Add to folder
We use cookies to ensure you get the best experience on our website
Got it!