A little tool I made to roll velcro strips into smaller rolls. It's a bit of a specific use case, but figured it couldn't hurt to upload.

We use velcro a lot at work for cable management and such, and we buy them in big rolls. I like to have a more pocketable size to carry around, and I usually just roll out a bit and roll it by hand. It just bugs me how tedious it is to roll it into a nice even roll, so I made this little tool.

To use, just connect the two pieces and slide the end of the velcro through the middle. You'll want to make sure you make a full stuck loop on the base as it keeps it from spinning on the tool. Then just roll it. You can roll the tool around the roll of velcro, or pull it out and roll it loose. When you're done, just separate the pieces and you have a nice evenly rolled section of velcro to carry with you.

This is made to fit 1/2 in or 12mm wide rolls.

Hook and loop 3D Print Models & Free STL Files