Gothic Arch 2403.9 mm x 1066.8 mm. Update 6/11/202/ I am working on fixing the Column-Right-10 and Column-Left-10 so they match. Also will be adding an update to be able to print the upper arch sections in a 220mm x 220mm x 250mm prtint area. Please enjoy and any feedback is welcome, I am new here and to printing.

I will upload pictures of the finished arch when I am done.

Update: June 19th 2026, column 10 for both sides are fixed.

Update: June 20th 2026, V2 of the Arch will use the pins and can be printed on a smaller bed.

Update: October 31st 2026, one of the columns broke during transport, I used CA glue with setting spray to repair on site and it held up for the event. Mounting was 1/4" carriage bolts 6" long through a 3/4" plywood square 42" x 48".

Print settings:

Note: these changed throughout this project as this was my first real project and I learned a lot.

Column Right and Left #1

Material:PLA

Original infill density: 15%

Infill style: Gyroid

The remaining columns:

Material:PLA

Infill density: 5%

Support: tree(auto)

Infill style: Gyroid

Top of the Arch:

Material:PLA

Infill density: 5%

Support: tree(auto)

Bottom shell layers: 5

Bottom thickness: 0.8 mm

Brim/Adhesion: Outer only

Top layer ironing

Gothic Ach

Noobsauce

Printinstellingen(0)

Beschrijving

Licentie

Tags

Gerelateerde modellen