Hey! I tried to think outside of the box for a relief fidget toy. In theory, spending the excess energy and tiring up the the ears and brain a little should help relieving the stress. So a fidget toy like this should work. But in reality it turns out that this toy has a side effect! "while it helps user to relieve the stress, it annoys the people around pretty much. " Thus i represent you "The Stress Transfer Drum". Secondary use purpose: Print a couple of these for your children before you drop them to your mother in law for the weekend. Don't forget to grab your popcorn while you are turning back to pick them up. It should help relieve your stress. Wish me luck in the competition, May the perfect first layer be with you, See you on the next design![%1786422819] Print Settings Nothing unusual with this one. No support needed, 10% infill is enough. Use the rest of the settings same as you usually do or leave as default Recommended filament: i used esun silk pla for the test print in visuals, using similar is recommended to have beautiful colors & a nice printing+ assembly experience. Assembly its pretty straightforward, Handle goes into drumbody, then shove a small piece of filament to the hole in the handle to secure it in the place, drumbody has 2 tiny holes on the sides where the string/fishing line should pass, then you need to tie the hammers on two ends of the spring. You can facilitate some knots on the sting to secure it in the place so the hammers always has equal distance/arm length. Drum caps are screw-on. There are 2 hammer designs, choose according to your wish.