Hi everyone! I’m posting about a big problem I’m having while printing with the new Soleyin Ultra PLA filament on my K1 max. Until now I normally would use Creality Hyper PLA, with no problem, but recently I bought a batch of Soleyin and every time I tey to use it, it causes a really big mess. It already destroyed two hotend, one geniune creality hotend and one microswiss, also it destroyed my unicorn nozzle by filamnet not sticking in the bed, and swelling like crazy and sorrounding the whole hotend untill it cut wites on the heating element. Two times it happen while leting the print unattended, because it was printing perfectly so i only switchet the filament from Creality HP to Soleyin and the filament profile on slicer. After the first time I switched the hotend and calibrated filament settings, and also dried the filement using creality space pi, and in the middle of print it had started to create the same masive bloob. When extruding it creates a wierd uneven flow with small bubbles even though the the filament was dry. Is anyone els having similar problems, Can you hep me solve this problem? p.s filament wont stick in any build plate with or without glue.