Waste (Poop) chute for the K2 Pro.

My first creation as a beginner. Couldn't find any for the new K2 Pro so had to design my own and this is what I came up with.

I printed this in PETG with generic Creality settings and profiles, using normal supports.

For right side.

It does have two small 1mm runners along the back side that fit into the waste port to help hold it aligned in place (Not really needed but I'm a little OCD for over doing things)

Modified this a little by removing the deflector ramp at the bottom of the chute as it didn't work as I'd hoped.

I was also having some dramas with waste getting stuck at the top so I've made it a bit wider( now 50mm) hopefully this solves the problem.