Came out pretty well, I thought it would be nice to do a two color on the drawer, had I thought of it earlier might have done the two color on all holding pieces as well, would probably look even better. I got these stick on PATIKIL Non Slip Furniture rubber pads sized 40mmX5mm feet from amazon https://amazn.so/tcdGYrJ which hold things rock stead with new slip and I believe help with printer vibrations. I do wish there were ears with screw holes on the top half of the waste shoot so it could be screwed down, like I had my previous waste system. Perhaps magnet mounts as well, in the lower half of the shoot. I am not overly keen on the taping it to the back which I did poorly with electrical tape for now.