Hey guys, i'm searching for settings to start with. I've spent several hours for PLA and the stringing doesn't stop. What settings are working for you? I've started with the settings from my old anycubic and did more and more finetuning. My last stringing problem is, the print is getting "hairy/fluffy". I'm using PLA from Geetech. Initial Layer Width: 130% Print Temp: 190°C Init Temp: 200°C Plate Temp: 60°C Flow: 105% (otherwise the surfaces are underextruded - yes already calibrated) Init Flow: 110% Speed: 180mm/s Travel Speed: 250mm/s Init Speed: 25mm/s ZHop Speed: 8mm/s Retract Dist: 0.5mm Retract Speed: 180mm/s (i'm not sure the printer can this speed, only testing) Combing: Off ZHop when Retraced ZHop only over printed parts ZHop Height: 0.2 Cooling: 100% I'm pretty sure it's the retraction. Cause it's the only setting that change the stringing results. But I'm not able to find the perfect point. So maybe I missed another setting.