Hi ! My print of "Elephant Desktop Frame" by "Bamingo Design" Printer: "Ender-3 V3 SE" Scale: 100% Sliced with: Creality Print v4.3.6 (material "CR-PLA", quality "Normal") File "frame7_stand.stl" Layer height: 0.2 mm Filament used: ArianePlast PLA recyclé Printing time: ~ 0h53 File "frame7_front.stl" Layer height: 0.2 mm Filament used: ArianePlast PLA recyclé Printing time: ~2h59 File "frame7_back.stl" Layer height: 0.2 mm Filament used: ArianePlast PLA Eco Blanc Printing time: ~3h26 File "Elephant_v2_edited120mm.stl" Layer height: 0.15 mm Adhesion type: Brim Printing supports: "Strong tree" with also a brim for the supports. (avoid "light tree" too fragile, made me miss a print...) Filament used: Anycubic PLA High speed gray Printing time: ~ 4h29 After removing the supports, a quick blast of flame with a lighter to remove the angel hair, deburring, beveling to remove the defects and allow the fittings, and used glue to hold the elements in place. Posted as an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c Good continuation to all !