AEDRAG06 – Dragons of Aach’yn: Gearheart FTW - For the WIN lol I printed this model at 80% height on my Creality CR10-SE I could have slowed it down in speed but I wanted to have it finished in time for the Dragon Printing Competition. It is a Very difficult 3d Print to Print with a FDM printer, especially with so much detail. If I had more time I know I could do better. Printed @300mms Creality Hyper PLA+, Matt White Creality Print Slicer 10% Grid Infill 3x layers lines 20% Whole wall Speed within 10mm Diameter threshold 10% small Perimeter speed No Supports Bridge Enabled Chris_Creations YTB: https://www.youtube.com/channel/UCcMwfrtAFEqRI_GUy7QEncw

Silver Flexi Dragon Print Printed in E Sun Silk Metallic Gray 0.16mm layer 10% Gyroid Infill speed @200mms 7+hrs with small parameters at 10% mms Not my Best Print but tried to print this one in a hurry for last minute dragon competition addition. Should have Dried out the Filament for longer before printing and it would have been better quality as moisture was in the filament, unfortunately.