Pretty happy with this one overall. First print was a fail. I printed it as it is in the file, but it needs Supports that AREN'T included in the file. I decided i wanted to use it differently so i split it down the centre and only printed the front half. I added some supports and shrunk it down to 80%. Super happy. File also has a fault at a seam. It's printed the fault repeatedly in the same place, so you might want to increase the width of the external wall. Alternatively, i just heat some scraps afterwards and melt them into position 👌

 Designers 

 Workbench

 Messages

 English 













19:02 06-30-2024