Anyone else have an issue with the creality octoprint plug in? I can install it in safe mode but I’m never able to see it in the settings to add the key. I have octopi installed on a raspberry pi 3 and its controlling an ender 3. That’s all working well and I’m streaming on a webcam I just can’t seem to connect to creality cloud. Edit: I still was not able to get this working with plug in after lots of troubleshooting. So I downloaded Prusa Slicer and was able to add the octoprint printer in 10 minutes and submit my first print from Prusa. I am going to switch over to Prusa Slicer entirely unless I have any other problems.