Canine Snout Mask, by Perihelion Prints

======

This playful canine snout mask is suitable for a masquerade party, as part of a dog/canine cosplay, or for a performance costume. Scaled to fit most adult heads.

For attachment to head, use elastic cord or ribbon. For fitting, place the mask on your face, lining it up with your nose and the sides of your face.

Ideally you will want to make a strap around your neck and another above your ears, as shown in the pictures. Measure how much ribbon you'l need to go around your neck from the bottom of the mask, then add a bit more and cut two equal halves. Glue one to each side of the mask, and use the leftover length to tie both pieces into a knot/bow behind your head. Repeat this process for the ear straps.

You may want to put a piece of foam on the inside of the mask, so it doesn't hurt your nose. You may also want to scale the mask down in the X axis by 5-10% if you have a narrower face.

Sculpted in Blender. STL included. Dimensions in millimetres.

======

"demo_dress" used in demo render (https://skfb.ly/opoQD) by emilysa is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

"ku" used in demo render (https://skfb.ly/oRRox) by warrio bhai is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

"Olivia free fire" used in demo render (https://skfb.ly/oJBwI) by Xman is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

"Realistic Female" used in demo render (https://skfb.ly/owqND) by Biviyt is licensed under Creative Commons Attribution-ShareAlike (http://creativecommons.org/licenses/by-sa/4.0/).

"SUNGLASSES FLOW" used in demo render (https://skfb.ly/6RBUq) by ChechoGimenez is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

"Susan" used in demo render (https://skfb.ly/HVnr) by lioness7 is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

"Yafiquí Llumú (Princess of the moon) V 1.0" used in demo render (https://skfb.ly/6WnVD) by IngWill is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/).

======

0.20mm layer height recommended.

Use supports where appropriate - organic supports recommended. Brim also recommended. Experiment with the orientation to minimize the amount of support material required.

15% infill tested. PLA recommended.

Filament Usage (estimated): 145g

Printing Time (estimated): 12h

^ Estimates based off slicing for Prusa MK3.9. Your mileage may vary.

Canine Snout Mask

Perihelion Prints

Printinstellingen(1)

0.2mm layer, 2 walls, 15% infill

Beschrijving

Licentie

Tags

Gerelateerde modellen