Unfortunately my printer disconnected 51 minutes into the print from the Creality WIFE/Camera and it won't restart. Anyone else having trouble with this? I digress. Support was easily removed by ✋️, but the BOTTOM didn't seem to separate from the simple raft I use for adhesion. Also concerned about under FRONT not having a wall. Any suggestions about the distortion left and right of the words? Layer height 0.15mm Temp 250/100(max) Support yes(everywhere) Adhesion simple raft Top/bottom 3.00mm Retract enabled Thanks in advance for any assistance, Dan

21:18 06-19

Volgen

Unfortunately my printer disconnected 51 minutes into the print from the Creality WIFE/Camera and it won't restart. Anyone else having trouble with this? I digress. Support was easily removed by ✋️, but the BOTTOM didn't seem to separate from the simple raft I use for adhesion. Also concerned about under FRONT not having a wall. Any suggestions about the distortion left and right of the words? Layer height 0.15mm Temp 250/100(max) Support yes(everywhere) Adhesion simple raft Top/bottom 3.00mm Retract enabled Thanks in advance for any assistance, Dan

6 calibration 6 sided with protruding names say and moor-0

6 calibration 6 sided with protruding names say and moor-1

6 calibration 6 sided with protruding names say and moor-2

6 calibration 6 sided with protruding names say and moor-3

6 calibration 6 sided with protruding names say and moor-4

6 calibration 6 sided with protruding names say and moor-5

6 calibration 6 sided with protruding names say and moor-6

 Rapporteren



Commentaar



Afbeelding