🙋‍♂️Arc Configure Enable: The setting everyone told you to turn off… They said it was to eliminate artifacts 👉🤓 ⁉️🤨Has this been resolved yet?? ⚙️🛠️👉I’m interested in leveraging this setting. ⁉️Why?⁉️👇 Depending on what you’re printing and the demands of that file, ARC configurations are intended to produce: 💥90 DEGREE OVERHANGS 🧗‍♀️ ➕NO SUPPORTS required..😳 The magnificent circular movements that gradually bridge out to do the impossible by allowing extreme angles to be carved out (without supports) and offer a quality print.. 🎙️Majority says: “Turn it off and rip the knob off!” 🤦‍♂️Why? How bad are the artifacts? Was it just a BUG?🐛 I’m curious if this is common thread due to: 👉Owners lacking knowledge on how to truly dial in the settings and leverage print profiles. Assuming this setting isn’t commonly used (not every print has cliff hangers) then if it does in fact create artifacts, I understand disabling the feature. However, for those of us who dislike ripping off supports (that leave behind awesome cheesey finishes) has the artifact issue been resolved? Will it be? And what’s a workaround anyone has noticed to have Arc Configure enabled while producing overal print quality that passes the bullshit test?