This is a Santa head i had sculpted within SculptGL. i had printed it on a bamboo printer X1 and the results were pretty nice! just make sure to print it laying at a 45 degree angle with the chin pointing down. Id say this wouldn't be a very good resin print, the ball on the hat and the beard might be a tough challenge for resin printing, and it is because of these features that i only recommend FDM printing. Lastly, this print contains a lot of attention to detail, so i also recommend printing at high resolution and at slow/steady speeds to maximize the quality and detail i've integrated into the design. enjoy! ~[%8357483224]