Hi all, I thought I would try printing a 50mm x 50mm lithophane that I could hang on a mirror. I decided to try it using my Ender 5s1, but increased the Temps to match my K1Max at 220 nozzle temp and a hotbed temp of 50. The slicer stood the coins on end so I added supports(new to this) and attempted the print. It laid down the first layer of the supports and the coin but shortly after this the support lifted from table a bit and then the whole print just threaded. My question is has anyone tried printing a lithophane flat to the bed or do they have to stand? I have printed gobs of lithophanes but they always are standing, could it be that there is not enough surface area to stick to the bed, possibly add a raft maybe?