Introducing our lightweight Ender-3 V3 SE nozzle fan mount mod! Less than 25% of the weight of the original cover, resulting in less vibrations from printer movements. Focuses air from the fan straight onto the nozzle for improved part cooling efficiency. Easy to print and install, uses all stock hardware.

Instructions:

1. Remove the stock hot end cover by using a hex key to unscrew the outer bolts on both sides. Remove the screws connecting the fan from the housing. Set aside the fan, bolts, and screws for the upgraded mount install.

2. Face the opening on the fan towards the vent on the bottom of the hot end cover and line up holes for the stock m2 screws. Attach the 4 screws with the longer ones in the holes at the bottom of the mount. Do not overtighten.

3. Using the bolts to attach the new mount to the right side of the print head (from front of printer) with the opening facing towards the nozzle.

4. Recalibrate and you’re good to go!

Print Settings:

Easy print in place with no supports. Prints in most materials on standard settings.

Printed in PLA on an Ender-3 V3 SE:

- 180 mm/s print speed

- 0.2 mm layer quality

- 2 line wall count

- Supports: No

- Brim: No

- Infill: Concentric, 15%

- Temp: 195 degree nozzle, 65 degree bed (Textured PEI)

Thanks for checking it out! Head over to my page or follow for more useful mods and cool prints!

Ender-3 V3 SE Lightweight Hot End Fan Mount Upgrade

3dGohst

Druckeinstellungen(1)

0.2mm layer, 2 walls, 15% infill

Beschreibung

Standardlizenz

Tags

Verwandte Modelle